Sulzer Pump Selection-manufacture,factory,supplier from China

Typical Applications• Acid transfer• Brine• Chemical processing• Petrochemical processing• Corrosive services• Food and beverage processing• Hydrocarbon processing• Pharmaceuticals• Polymers• Pulp and paper• Seawater• Slurries• Solvents• Steel and primary metals• Water and wastewater treatmentContact me for selection and quotation if any needs.

1. Does the vibration generated when the vacuum pump works have any influence on the process and environment? If the process is not allowed, choose a pump without vibration or take anti-vibration measures.2. Understand the composition of the pumped gas, whether the gas contains condensable vapor, whether there is particulate dust, whether there is corrosiveness, etc. When choosing a vacuum pump, you need to know the gas composition, and select the corresponding pump for the pumped gas.

ANSI Mark III 4x3-10H bare shaft pump in WCB material, other materials like CD4M, CF8M, A20 etc are all available. And our pumps are 100% interchangeble with leading enterprise's one.If any needs, pls contact me for quotation.

Main applicationsBoiler feedHigh-pressure unit charge in refiningEthylene shippingOnshore and offshore waterfloodOffshore crude shippingOur pump is 100% interchangeble with original one, if any needs, pls contact me for quotation.

This kind of pump is used for all normal pumping applications, with stocks up to 8%, e.g., liquors, water, chemicals, white water, condensate, etc.Capacities 11,000 m³/h / 48,400 USgpmHeads 160 m / 525 ftPressures 16 / 25 bar, 230 / 360 psi,depending on material and sizeTemperatures 180 °C / 356 °FPls let me know if you have any needs.

 The working principle of the engine water pump: Through the belt pulley to drive the pump bearing and the impeller to rotate, the cooling liquid in the pump is driven by the impeller to rotate together, and is thrown to the edge of the pump shell under the effect of Centrifugal Force, at the same time generating certain pressure, and then it comes out of a drain or a pipe.

We are at Pump&Fluid Euipment Exhibition

First. Classification by impeller number 1. Single-stage pump: that is, there is only one impeller on the pump shaft. 2. Multi-stage pump: that is, there are two or more impellers on the pump shaft, and the total lift of the pump is the sum of the lifts generated by n impellers. Second, classified according to work pressure 1. Low-pressure pump: the pressure is less than 100m H2O; 2. Medium pressure pump: the pressure is between 100 and 650 meters of water column; 3.

Our chemical process pump provides outstanding hydraulic performance, unrivaled reliability and low total cost of ownership.

If you have any pump parts to be copied, pls contact me for quotation.The material like Titanium, Nickle, Hastelloy C, Stainless Steel, Cast Steel etc are all available.

The hydraulic design of two-phase flow pulp pump adopts the principle of “Relative suction and relative blocking”in the theory of two-phase flow, so that the hydraulic performance of the flow parts of the pump conforms to the law of solid-liquid two-phase flow, thus reducing the slurry flow parts of the erosion and wear, greatly improving the efficiency and service life of the pump, the pump series has the following notable features:1.High efficiency and energy saving: The running efficiency is 3-10 percentage points higher than the average of the ordinary pulp pump, the energy saving and cons

Water leakage (water leakage is split into minor and excessive) minor water leakage will best depart traces of coolant coloration on the vent of the water pump. the severe trouble is direct water leakage, which ends up in excessive water temperature after lack of coolant.Weak circulating capacity: If the circulating capacity of the water pump is weak, the water temperature will be high, especially in summer in the south.